Airworthiness Directives; Airbus SAS Airplanes

ローカル自動翻訳 · 情報源の原言語

概要

The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by an in-service inspection that found overhead storage compartment (OHSC) crash rods that were disconnected. This AD requires a one-time detailed inspection of the OHSC crash rods and, depending on findings, corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

情報源の原言語: Federal Register — Federal Aviation Administration原文の発表を開く →

会社を追加

ビジネス情報源を監視し、Business Communicatorの企業やプロフィールにつなげます。

無料の企業プロフィールを作成 Business Mapsで企業を探す →

無料の企業プロフィールを作成 →

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200 series airplanes; Model A330-200 Freighter series airplanes; Model A330-300 series airplanes; and Model A330-841 and -941 airplanes. This AD was prompted by a report of an in-service event and relevant investigation which found that, under specific conditions, a dormant failure of a standby fuel pump could lead to a certain amount of fuel being trapped in the aft section of the inner tank that would be unusable. This AD requires repetitive operational checks of the standby fuel pumps and corrective actions and limits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.

概要を読む →

ビジネス · 2026/5/14

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by the obsolescence of the clamp holding in place the oxygen generator in the container and introduction of a new clamp from another manufacturer with different locking torque specifications, which were not properly reflected in Airbus documentation. This AD requires replacing each affected part, prohibits accomplishing maintenance actions using certain versions of a maintenance procedure task, and also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

概要を読む →

ビジネス · 2026/5/14

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320 series airplanes; and Model A321-211, - 212, -213, -231, -232, -251N, -251NX, -252N, -252NX, -253N, -253NX, - 271N, -271NX, -272N, and -272NX airplanes. This AD was prompted by a review of the cold working process on the assembly line that detected a deviation to the manufacturing process. This AD requires repetitive inspections for the nominal design condition of the fastener holes in the pressure deck membrane to center wing box attachment and, as applicable, an inspection for cracking at the affected area and corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.

概要を読む →

ビジネス · 2026/5/22

Airworthiness Directives; Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Embraer S.A. Model ERJ 190-100 ECJ airplanes. This AD was prompted by a manufacturing quality escape concerning certain overheat detection system (ODS) sensing elements. This AD requires a detailed inspection of certain ODS sensing elements of the airplane bleed lines and replacement, if necessary. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

概要を読む →

ビジネス · 2026/5/22

Airworthiness Directives; Bombardier, Inc., Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-1A10 and BD-700-1A11 airplanes. This AD was prompted by reports that inappropriate tooling was used to torque the bolts securing the baggage door stop fittings, which may have resulted in an improper torque condition. This AD requires performing a torque check of affected bolts and re-torquing, re- installing, or replacing affected bolts and nuts as applicable. The FAA is issuing this AD to address the unsafe condition on these products.

概要を読む →

ビジネス · 2026/5/21

Airworthiness Directives; Bell Textron Canada Limited Helicopters

The FAA is adopting a new airworthiness directive (AD) for certain Bell Textron Canada Limited (BTCL) Model 407 helicopters. This AD was prompted by a determination that chafing can occur at various locations on the electrical harnesses located in the aircraft instrument panel area. This AD requires a one-time detailed visual inspection of the electrical harnesses for chafing and corrective actions if necessary. This AD also requires rotation of the backshell cast housing of connectors of the lower engine airframe unit and installation of a wire harness bracket and support, and for certain helicopters, installation of a wire bundle sleeve. The FAA is issuing this AD to address the unsafe condition on these products.

概要を読む →