Federal Motor Vehicle Safety Standards; Door Locks and Door Retention Components

Riepilogo

This final rule delays the compliance date of the sliding door provisions of a February 6, 2007 final rule, from September 1, 2009 to September 1, 2010. The February 6, 2007, final rule amended the Federal motor vehicle safety standard on door locks and door retention components to add and update requirements and test procedures and to harmonize with the world's first global technical regulation for motor vehicles. NHTSA received four petitions for reconsideration of that final rule, including two that requested a delay in the effective date of the sliding door provisions of the rule, and others which raised concerns about some of the new test requirements and procedures. To accommodate manufacturers' design and production cycles while allowing the agency more time to analyze the petitions in regards to other issues, the agency is delaying the compliance date of the sliding door provisions of S4.2.2 until September 1, 2010.