Airworthiness Directives; Boeing Model 737-100, -200, -200C, - 300, -400, and -500 Series Airplanes

Resumen

This document proposes the supersedure of an existing airworthiness directive (AD), applicable to certain Boeing Model 737- 100, -200, -200C, -300, -400, and -500 series airplanes, that currently requires a one-time inspection of the attachment nuts at each end attachment of the elevator tab push rods to measure run-on torque values, and corrective actions, if necessary. This action would add a requirement to replace all existing bolts and attachment nuts at the forward and aft end attachment of each elevator tab push rod with new bolts and self-locking castellated nuts with cotter pins. This proposal is prompted by reports of excessive high-frequency airframe vibration during flight, with consequent structural damage to the elevator tab, elevator, and stabilizer. The actions specified in this AD are intended to prevent detachment of an elevator tab push rod due to a detached nut at either end attachment of a push rod, which could result in excessive high-frequency airframe vibration during flight; consequent structural damage to the elevator tab, elevator, and horizontal stabilizer; and reduced controllability of the airplane.