BN Business News
Business Maps⌕ Business News'te ara
Şirketinizi ekleyin →
Bu çeviri hazırlanıyor. Bu süre içinde İngilizce orijinal sürümü gösteriyoruz.

İş dünyası · 12.10.20051 dk okuma

Airworthiness Directives; Boeing Model 727, 727C, 727-100, and 727-100C Series Airplanes

Yerel otomatik çeviri · Kaynağın orijinal dili

Özet

This amendment adopts a new airworthiness directive (AD), applicable to certain Boeing Model 727, 727C, 727-100, and 727-100C series airplanes. This AD requires repetitive inspections of the frame inner chord, outer chord, and web of the forward and aft edge frames of the lower lobe forward cargo door (FCD) cutout, and corrective action if necessary. The actions specified by this AD are intended to detect and correct fatigue cracking of the forward and aft edge frames of the lower lobe FCD cutout, which could result in the loss of the FCD and rapid decompression of the airplane. This action is intended to address the identified unsafe condition.

Kaynağın orijinal dili: Federal Register — Federal Aviation AdministrationOrijinal duyuruyu açın →

Konuları keşfedin

İş dünyası analizleri →
6

İş dünyası · 14.05.2026

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320 series airplanes; and Model A321-211, - 212, -213, -231, -232, -251N, -251NX, -252N, -252NX, -253N, -253NX, - 271N, -271NX, -272N, and -272NX airplanes. This AD was prompted by a review of the cold working process on the assembly line that detected a deviation to the manufacturing process. This AD requires repetitive inspections for the nominal design condition of the fastener holes in the pressure deck membrane to center wing box attachment and, as applicable, an inspection for cracking at the affected area and corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.

Özeti okuyun →

İş dünyası · 22.05.2026

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200 series airplanes; Model A330-200 Freighter series airplanes; Model A330-300 series airplanes; and Model A330-841 and -941 airplanes. This AD was prompted by a report of an in-service event and relevant investigation which found that, under specific conditions, a dormant failure of a standby fuel pump could lead to a certain amount of fuel being trapped in the aft section of the inner tank that would be unusable. This AD requires repetitive operational checks of the standby fuel pumps and corrective actions and limits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.

Özeti okuyun →

İş dünyası · 14.05.2026

Airworthiness Directives; Dassault Aviation Airplanes

The FAA is superseding Airworthiness Directive (AD) 2023-22- 05, which applied to certain Dassault Aviation Model FAN JET FALCON and FAN JET FALCON SERIES C, D, E, F, and G airplanes. AD 2023-22-05 required revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. Since the FAA issued AD 2023-22-05, the FAA has determined that new or more restrictive airworthiness limitations are necessary. This AD continues to require certain actions in AD 2023-22-05 and requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is issuing this AD to address the unsafe condition on these products.

Özeti okuyun →

İş dünyası · 22.05.2026

Airworthiness Directives; Bombardier, Inc., Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-1A10 and BD-700-1A11 airplanes. This AD was prompted by reports that inappropriate tooling was used to torque the bolts securing the baggage door stop fittings, which may have resulted in an improper torque condition. This AD requires performing a torque check of affected bolts and re-torquing, re- installing, or replacing affected bolts and nuts as applicable. The FAA is issuing this AD to address the unsafe condition on these products.

Özeti okuyun →

İş dünyası · 14.05.2026

Airworthiness Directives; Dassault Aviation Airplanes

The FAA is superseding Airworthiness Directive (AD) 2023-20- 05, which applied to certain Dassault Aviation Model MYSTERE-FALCON 20- C5, 20-D5, 20-E5, and 20-F5 airplanes. AD 2023-20-05 required revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. Since the FAA issued AD 2023-20-05, the FAA has determined that new or more restrictive airworthiness limitations are necessary. This AD continues to require certain actions in AD 2023-20-05 and requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is issuing this AD to address the unsafe condition on these products.

Özeti okuyun →

İş dünyası · 22.05.2026

Airworthiness Directives; Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Embraer S.A. Model ERJ 190-100 ECJ airplanes. This AD was prompted by a manufacturing quality escape concerning certain overheat detection system (ODS) sensing elements. This AD requires a detailed inspection of certain ODS sensing elements of the airplane bleed lines and replacement, if necessary. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

Özeti okuyun →