BN Business News
Business Maps⌕ Pesquisar no Business News
Adicionar empresa →
Esta tradução está a ser preparada. Entretanto, mostramos temporariamente a versão original em inglês.

Negócios · 29/09/19981 min de leitura

Airworthiness Directives; Raytheon Aircraft Company 200 Series Airplanes

Tradução automática local · Idioma original da fonte

Resumo

This amendment adopts a new airworthiness directive (AD) that applies to Raytheon Aircraft Company (Raytheon 200 series airplanes. This AD requires revising the FAA-approved Airplane Flight Manual (AFM) to specify procedures that would prohibit flight in severe icing conditions (as determined by certain visual cues), limit or prohibit the use of various flight control devices while in severe icing conditions, and provide the flight crew with recognition cues for, and procedures for exiting from, severe icing conditions. This AD was prompted by the results of a review of the requirements for certification of these airplanes in icing conditions, new information on the icing environment, and icing data provided currently to the flight crew. The actions specified by this AD are intended to minimize the potential hazards associated with operating these airplanes in severe icing conditions by providing more clearly defined procedures and limitations associated with such conditions.

Idioma original da fonte: Federal Register — Federal Aviation AdministrationAbrir o comunicado original →

Explorar análises

Análises empresariais →
6

Negócios · 14/05/2026

Airworthiness Directives; Dassault Aviation Airplanes

The FAA is superseding Airworthiness Directive (AD) 2023-22- 05, which applied to certain Dassault Aviation Model FAN JET FALCON and FAN JET FALCON SERIES C, D, E, F, and G airplanes. AD 2023-22-05 required revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. Since the FAA issued AD 2023-22-05, the FAA has determined that new or more restrictive airworthiness limitations are necessary. This AD continues to require certain actions in AD 2023-22-05 and requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is issuing this AD to address the unsafe condition on these products.

Ler o resumo →

Negócios · 22/05/2026

Airworthiness Directives; Airbus Helicopters

The FAA proposes to supersede Airworthiness Directive (AD) 2023-25-14, which applies to certain Airbus Helicopters Model EC130T2 helicopters. AD 2023-25-14 revises the procedures for inspecting the vibration level on the tail rotor drive shaft and, depending on these results, requires replacing certain parts. Since the FAA issued AD 2023-25-14, the manufacturer developed a modification of the rear drive shaft, sliding flange and equipped splined sleeve. This proposed AD would require installing this modification and repetitively inspecting the vibration level of the tail rotor drive shaft. This proposed AD would also prohibit the installation of certain parts and prohibit the performance of a balance correction unless certain requirements are met. The FAA is proposing this AD to address the unsafe condition on these products.

Ler o resumo →

Negócios · 22/05/2026

Airworthiness Directives; Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Embraer S.A. Model ERJ 190-100 ECJ airplanes. This AD was prompted by a manufacturing quality escape concerning certain overheat detection system (ODS) sensing elements. This AD requires a detailed inspection of certain ODS sensing elements of the airplane bleed lines and replacement, if necessary. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

Ler o resumo →

Negócios · 22/05/2026

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200 series airplanes; Model A330-200 Freighter series airplanes; Model A330-300 series airplanes; and Model A330-841 and -941 airplanes. This AD was prompted by a report of an in-service event and relevant investigation which found that, under specific conditions, a dormant failure of a standby fuel pump could lead to a certain amount of fuel being trapped in the aft section of the inner tank that would be unusable. This AD requires repetitive operational checks of the standby fuel pumps and corrective actions and limits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.

Ler o resumo →

Negócios · 15/05/2026

Airworthiness Directives; Pilatus Aircraft Ltd. Airplanes

The FAA is revising a notice of proposed rulemaking (NPRM) that would have applied to certain Pilatus Aircraft Ltd. (Pilatus) Model PC-12 airplanes. This action revises the NPRM by changing the applicability. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over those in the NPRM for different airplanes, the FAA is requesting comments on this SNPRM.

Ler o resumo →

Negócios · 14/05/2026

Airworthiness Directives; Dassault Aviation Airplanes

The FAA is superseding Airworthiness Directive (AD) 2023-20- 05, which applied to certain Dassault Aviation Model MYSTERE-FALCON 20- C5, 20-D5, 20-E5, and 20-F5 airplanes. AD 2023-20-05 required revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. Since the FAA issued AD 2023-20-05, the FAA has determined that new or more restrictive airworthiness limitations are necessary. This AD continues to require certain actions in AD 2023-20-05 and requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is issuing this AD to address the unsafe condition on these products.

Ler o resumo →