BN Business News
Business Maps⌕ البحث في Business News
أضف شركتك →
تجري حاليًا ترجمة هذا المقال. نعرض مؤقتًا النسخة الأصلية باللغة الإنجليزية.

الأعمال · 8‏/1‏/20211 دقائق للقراءة

Federal Motor Vehicle Safety Standards; Motorcycle Brake Systems; Motorcycle Controls and Displays

ترجمة آلية محلية · اللغة الأصلية للمصدر

الملخص

This document amends Federal Motor Vehicle Safety Standards (FMVSS) Nos. 122 and 123 to allow the use of an internationally recognized symbol. It also relocates the telltale specifications for anti-lock braking system (ABS) malfunction from FMVSS No. 101 to the appropriate table in FMVSS No. 123 since the latter applies to motorcycles. In addition, this final rule makes two technical corrections: It corrects motorcycle category references in S6.3.2 of FMVSS No. 122 and an outdated table reference found in FMVSS No. 135.

اللغة الأصلية للمصدر: Federal Register — National Highway Traffic Safety Administrationافتح البيان الأصلي →

استكشف الموضوعات

تحليلات الأعمال →
6

الأعمال · 8‏/5‏/2026

Kawasaki Motors Corp., U.S.A., Receipt of Petition for Decision of Inconsequential Noncompliance

Kawasaki Motors Corp., U.S.A. (Kawasaki) has determined that certain model year (MY) 1979-1981 and MY 2017-2025 Kawasaki motorcycles do not fully comply with Federal Motor Vehicle Safety Standard (FMVSS) No. 122, Motorcycle Brake Systems. Kawasaki filed a noncompliance report dated November 4, 2025, and subsequently petitioned NHTSA (the "Agency") on November 5, 2025, for a decision that the subject noncompliance is inconsequential as it relates to motor vehicle safety. This document announces receipt of Kawasaki's petition.

اقرأ الملخص →

الأعمال · 1‏/4‏/2026

Federal Motor Vehicle Safety Standards; Modernization of FMVSS No. 110 To Accommodate ADS-Equipped Vehicles

NHTSA is proposing to amend Federal Motor Vehicle Safety Standard (FMVSS) No. 110, "Tire selection and rims and motor home/ recreation vehicle trailer load carrying capacity information for motor vehicles with a GVWR of 4,536 kilograms (10,000 pounds) or less." The proposed modification would amend a single section of the standard to enable compliance by affixing the required placard on the left side of the vehicle when there is not a "driver's side" for vehicles equipped with Automated Driving Systems (ADS) that do not have manually operated driving controls. This rulemaking would allow flexibility in complying with the standard without detriment to vehicle safety. This action is part of a larger NHTSA effort to address vehicle automation in the agency's regulations.

اقرأ الملخص →

الأعمال · 11‏/3‏/2026

Zoox-Receipt of Application for Temporary Exemption From Various Requirements of the Federal Motor Vehicle Safety Standards for an Automated Driving System-Equipped Vehicle; Request for Comment

Zoox, Inc. ("Zoox") has petitioned NHTSA for a temporary exemption from certain requirements in eight Federal Motor Vehicle Safety Standards (FMVSS) applicable to its passenger car equipped with an automated driving system (ADS). Specifically, Zoox seeks exemption from portions of FMVSS No. 103, Windshield defrosting and defogging systems; FMVSS No. 104, Windshield wiping and washing systems; FMVSS No. 108, Lamps, reflective devices, and associated equipment; FMVSS No. 111, Rear visibility; FMVSS No. 135, Light vehicle brake systems; FMVSS No. 201, Occupant protection in interior impact; FMVSS No. 205, Glazing materials; and FMVSS No. 208, Occupant crash protection. NHTSA is publishing this document in accordance with statutory and administrative provisions and seeks comment on the merits of Zoox's exemption application and on potential terms and conditions that should be applied to a temporary exemption if granted. After receiving and considering public comments, NHTSA will make a decision on the merits of the application and will publish a notice in the Federal Register setting forth NHTSA's reasoning for either granting or denying the petition.

اقرأ الملخص →

الأعمال · 8‏/4‏/2026

Agency Information Collection Activities; Notice and Request for Comment; Consolidated Labeling Requirements for Motor Vehicles (Except the VIN)

The National Highway Traffic Safety Administration (NHTSA) invites public comments about our intention to request the Office of Management and Budget (OMB) approval to reinstate with modification an information collection. Before a Federal agency can collect certain information from the public, it must receive approval from OMB. Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including reinstatement and modification of previously approved collections. This document describes a collection of labeling information on nine Federal Motor Vehicle Safety Standards (FMVSS) for which NHTSA intends to seek OMB approval. The labeling requirements include brake fluid warning for vehicles with a GVWR greater than 3,500 kilograms (7,716 pounds), brake fluid warning for vehicles with a GVWR of 3,500 kilograms (7,716 pounds) or less, glazing labeling, air bag warning labels, seat belt labeling, compressed natural gas (CNG) vehicle fuel label, CNG fuel container labels, hydrogen fueled vehicle fueling label, and hydrogen fuel container labels. NHTSA is also requesti

اقرأ الملخص →

الأعمال · 6‏/4‏/2026

Federal Motor Vehicle Safety Standards; Occupant Crash Protection, Seat Belt Reminder Systems

This interim final rule amends the seat belt warning requirements in Federal Motor Vehicle Safety Standard (FMVSS) No. 208, "Occupant crash protection" in response to petitions for reconsideration of the January 2025 final rule. This interim final rule delays the compliance dates and makes technical clarifications to the regulatory text. NHTSA denies the remainder of the requests. Though these amendments are effective immediately, to benefit from comments interested parties and the public may have, NHTSA requests that any comments be submitted to the docket for this rule. Following the close of the comment period, NHTSA will publish a final rule responding to any comments received and making any appropriate changes to the interim final rule.

اقرأ الملخص →

الأعمال · 16‏/3‏/2026

Federal Motor Vehicle Safety Standards; Modernization of FMVSS No. 103 and FMVSS No. 104 To Accommodate ADS-Equipped Vehicles; Incorporation by Reference

NHTSA is proposing to amend Federal Motor Vehicle Safety Standards (FMVSS) No. 103, "Windshield defrosting and defogging systems," and FMVSS No. 104, "Windshield wiping and washing systems." The proposed modifications would except vehicles equipped with Automated Driving Systems (ADS) that do not have manually operated driving controls from these standards. This rulemaking would remove unnecessary regulatory burdens and costs associated with systems intended to provide visibility for a person driving the vehicle. As these systems do not fulfill the same safety need on an ADS-equipped vehicle without manually operated driving controls, the proposed changes are not expected to have adverse safety effects. Manufacturers may still provide these systems if they choose to do so. These actions are part of a larger NHTSA effort to address vehicle automation in the agency's regulations. This proposal would also harmonize FMVSS Nos. 103 and 104 with current industry standards through incorporations by reference.

اقرأ الملخص →