BN Business News
Business Maps⌕ Wyszukiwarka Business News
Dodaj firmę do Business Communicatora →
To tłumaczenie jest jeszcze przygotowywane. Poniżej prezentujemy tymczasowo oryginalną wersję angielską.

Biznes · 14.05.20261 min czytania

Airworthiness Directives; ATR-GIE Avions de Transport Régional Airplanes

Automatyczne tłumaczenie lokalne · Oryginalny język źródła

Streszczenie

The FAA is adopting a new airworthiness directive (AD) for all ATR--GIE Avions de Transport R[eacute]gional Model ATR42-200, -300, and -320 airplanes. This AD was prompted by a report of an occurrence of a flap asymmetry detector and flap interconnection shaft having worn splines and not engaging mechanically. This AD requires a special detailed inspection (SDI) of the affected flap asymmetry detection mechanism, and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.

Oryginalny język źródła: Federal Register — Federal Aviation AdministrationOtwórz oryginalny komunikat →

Przeglądaj tematy

Centrum analiz biznesowych →
6

Biznes · 22.05.2026

Airworthiness Directives; Embraer S.A. (Type Certificate Previously Held by Yaborã Indústria Aeronáutica S.A.; Embraer S.A.) Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Embraer S.A. Model ERJ 190-100 ECJ airplanes. This AD was prompted by a manufacturing quality escape concerning certain overheat detection system (ODS) sensing elements. This AD requires a detailed inspection of certain ODS sensing elements of the airplane bleed lines and replacement, if necessary. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

Czytaj streszczenie →

Biznes · 22.05.2026

Airworthiness Directives; Bombardier, Inc., Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-1A10 and BD-700-1A11 airplanes. This AD was prompted by reports that inappropriate tooling was used to torque the bolts securing the baggage door stop fittings, which may have resulted in an improper torque condition. This AD requires performing a torque check of affected bolts and re-torquing, re- installing, or replacing affected bolts and nuts as applicable. The FAA is issuing this AD to address the unsafe condition on these products.

Czytaj streszczenie →

Biznes · 22.05.2026

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200 series airplanes; Model A330-200 Freighter series airplanes; Model A330-300 series airplanes; and Model A330-841 and -941 airplanes. This AD was prompted by a report of an in-service event and relevant investigation which found that, under specific conditions, a dormant failure of a standby fuel pump could lead to a certain amount of fuel being trapped in the aft section of the inner tank that would be unusable. This AD requires repetitive operational checks of the standby fuel pumps and corrective actions and limits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.

Czytaj streszczenie →

Biznes · 21.05.2026

Airworthiness Directives; Leonardo S.p.a. Helicopters

The FAA is adopting a new airworthiness directive (AD) for all Leonardo S.p.a. Model AB139, AW139, and AW189 helicopters. This AD was prompted by a report of cracks on the left-hand (LH) and right-hand (RH) tube assemblies installed on the brake pedal assemblies. This AD requires repetitively inspecting the LH and RH tube assemblies for Model AB139 and AW139 helicopters, and the LH and RH pedal shaft assemblies for Model AW189 helicopters, and depending on the results of the inspection, corrective actions. This AD also prohibits installing certain parts unless certain requirements are met. The FAA is issuing this AD to address the unsafe condition on these products.

Czytaj streszczenie →

Biznes · 14.05.2026

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by the obsolescence of the clamp holding in place the oxygen generator in the container and introduction of a new clamp from another manufacturer with different locking torque specifications, which were not properly reflected in Airbus documentation. This AD requires replacing each affected part, prohibits accomplishing maintenance actions using certain versions of a maintenance procedure task, and also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.

Czytaj streszczenie →

Biznes · 14.05.2026

Airworthiness Directives; Airbus SAS Airplanes

The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320 series airplanes; and Model A321-211, - 212, -213, -231, -232, -251N, -251NX, -252N, -252NX, -253N, -253NX, - 271N, -271NX, -272N, and -272NX airplanes. This AD was prompted by a review of the cold working process on the assembly line that detected a deviation to the manufacturing process. This AD requires repetitive inspections for the nominal design condition of the fastener holes in the pressure deck membrane to center wing box attachment and, as applicable, an inspection for cracking at the affected area and corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.

Czytaj streszczenie →